We may receive a commission for purchases from left.
Interior designer Nate Berkus has been in public for over 20 years and offers signature styles and expert insights to make the high-end aesthetics accessible to everyone that updates your home. We listen from his HGTV show to his best-selling books, when Berkus speaks to. And we rarely have to question the instructions. For this reason, a tip that deserves his frosted seal has surprised some and presented an unusual veiling of the covering, which can pull up the eyebrows in more than one way.
What kind of controversy trick is that? In an Instagram post, Berkus shows a hole in a carpet to hide the power cable of a lamp. It is necessary that the light works, and the cable can definitely pull down the appearance and make this trick into a seemingly clever way to make a wireless look at first glance. Then give it a few minutes and the problems will appear.
If you put aside security and practical ability to concern for a moment, you have to consider whether it is wise to cut your carpet at all. If you are interested in the design enough to hide your cables, you probably have not spent the facility. Would you like to ruin it willingly after you have found the perfect carpet for your room? Even if you hide the hole in its current place, forget to turn your carpet later to compensate for the wear. If you see the sustainable alternatives, it can be an unnecessary victim so that your floor lamp fits into the room without errors.
Why this trick for hiding your lamp cable is so controversial
While we are always ready for a Nate Berkus light tip to keep your home zen, a hole in the carpet will understandably raise a few red flags. If the technology exceeds the damage to a valuable property, the technology requires attention. The hole should be clean, even if your lamp covers it, only in case you want to move the carpet later. With a thoughtful approach, you can reduce the effect on the surface of the carpet. Do not ruthlessly start long holes. Cut a slot or x-shaped hole into the back with a sharp razor to better protect the surface fibers. You can then apply clear adhesive tape or melt the carpet slightly when it is synthetic to prevent the fray. If necessary, you can apply carpet tape to repair the cut as well as possible.
Despite a proper cut, carrying out your lamp cable with your carpet adds another problem: a fire risk. Carpets can create a heat trap, which may deteriorate the insulation. In addition to the risk of everyday walking that damages the wire, this can open the door to a serious fire. In general, the fire protection authorities underline the importance of the non -electrocabulary under carpets, carpet and furniture as a critical protective measure. Is it guaranteed that it causes problems? No, especially if the cable only runs through a short carpet section and does not exceed a walk. In view of the risk, if something goes wrong, it is worth exploring alternatives.
Alternatives to take into account before cutting a hole into your carpet
It can be difficult to look at someone who breaks a carpet just to hide a lamp cord, let alone imagine that they do so with their decor. If you are stuck in this phase and look for a way to align a wireless lamps, you can be sure that there may be a better solution. With floor lamps that usually depend on seating, you can run extension cables and insert concealer kits to move the lamp cord behind furniture and along the walls. You can also get rid of these annoying wires by playing with furniture setups and using decor such as plants and side tables to hide them.
Instead of cutting the carpet, also consider whether you cut the cord and go with an actual wireless light. Assign the room in a way that you want with a product like the GE LED+ Backup battery -LED -FLUGBABLE. The light bulb loads in a light and delivers cable -free lighting as a lamp lamp or flashlight. The disadvantage (apart from the costs) is that you can take a long time before you are charged and only offer a few hours of light with a full battery. They may not be convenient for frequently used devices, but for fabric lamps that mainly offer tasks or accent lighting occasionally, this can be a perfect way to get the desired appearance while keeping your RUG intact.